Recent content by allanrps

Sorry, the pictures were cleaned out with the rest of my google drive. Honestly, the conversion is pretty straight forward and I think you should have no problems without them. If you can, read some threads about a similar conversion for the xs650 and check out a schematic of a pma charging...

sorry I abandoned this, all the photos can be found here: https://drive.google.com/folderview?id=0B65265hYDAXibDQxLVo3MXZ4ODQ

Hi all, Recently while riding my my turn signals died out of the blue. I went home and found that the problem actually included the horn and the tail, indicator, and turn signal lights. I blew the fuse on that circuit. When I replaced the fuse I found that the problem occurs when the front or...

Well while your ignition timing and valve clearance may be fine now, down the road it will be a major pain in the ass if you need to adjust them. I learned this first hand. I'm about to put the stock flywheel on to set everything straight, then reinstall the pma system, hopefully with some more...

Glad to hear everything went well! I did the same thing when I first put the thing together. I'll probably add that to the guide if I can fit it. Is your new flywheel marked up?

I looked like there was like a 120 degree section on the cam shaft for each cylinder where both cams are at their 'zero', where it is round and doesn't lift the valve. Is there something I'm missing? Thanks for the help.

Nothing I haven't seen before, but I'll go at it again. I've been lodging the wrench holding the crankshaft into the footpeg/ground. I do have a non-stock flywheel with a measured TDC marking that is not 100% accurate, but from inspecting the camshaft I don't think it needs to be perfect TDC. I...

The thing is I've set the valves like a dozen times now. Check, double check, reset, check once more. Is there something about this I'm missing, because it seems pretty straight forward. TDC on the compression stroke, make sure they are loose, set gap, secure, check gap using multiple feeler...

I started my bike for the first time in quite a while, and the bike is very loud. The sound coming from the engine sounds like a loud clunking, not too different from the ticks the engine usually makes but quite loud. I did read that these bikes are loud when the valves are adjusted on the loose...

blabla, The reason I cut the plug was because the other connections are for the old charging system and are no longer needed. If you want , you could slice open the writing harness and get rid of the wires all together, but I just taped them up and his them. Are you still working on this? Would...

In my ignorance I did not realize that setting the valve lash is the same as setting the valve gap, I thought lash was at the cam. I did already set the gap multiple times, making sure the valve was in top position, but it is possible I messed that up. It is also possible that I might have set...

Great, that makes sense to me. I'll look into how to set those and get back with my results.

The top end was dripping wet when I took it off, so I don't think that's the issue. I forgot to add that I checked the valve clearances multiple times. Thanks for the help!

My bike had been misfiring and generally riding quite rough, so I decided to try to dial in the ignition timing. After setting my ignition timing statically, which in my specific situation led to concerns about having slightly bent a valve from sticking stuff down the spark plug hole, I tried...

Started the thing today. Had to use stater fluid to get it going, and once it started I heard this pretty loud clunking noise. I guess I know that means... I'll check the timing again just to make sure it's not premature detonation, but it doesn't sound like it to me. Off with the head I guess...