Anybody have a shift drum out that can take some pictures for me? I just had this thing together and proper, able to shift through all the gears, neutral was fine etc. Just tossed it back together and it seems I put the pawl blocking plate in the wrong spot in the pin area. If some one can snap a pic or two of it's proper position relative to the drum itself, it would be much appreciated.
I thought it went closest to the locating dowel on the pawl side, but when I have it there it will go through the gears and back over then get stuck in neutral, and I can see that the block doesn't let the pawls engage. So I for sure have it wrong.
I'll start moving it one position at a time til I find it, but would be nice to just get it right the first time after I take it back apart.
Thanks pals!
I thought it went closest to the locating dowel on the pawl side, but when I have it there it will go through the gears and back over then get stuck in neutral, and I can see that the block doesn't let the pawls engage. So I for sure have it wrong.
I'll start moving it one position at a time til I find it, but would be nice to just get it right the first time after I take it back apart.
Thanks pals!