swapping Break levers

[Keenzo]

I was wondering if a Honda CB brake lever fluid reservoir support a yamaha calliper? I like the look of the honda levers better than my Yamaha's also I want to get these levers that's why I want to covert. http://www.ebay.com/itm/190894279431?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2648

 

[dodger0129]

I was wondering if a Honda CB brake lever fluid reservoir support a yamaha calliper? I like the look of the honda levers better than my Yamaha's also I want to get these levers that's why I want to covert. http://www.ebay.com/itm/190894279431?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2648

I am using Honda CB levers,and a reservoir on my chopper,which has a Yamaha XS400 front end and disc/caliper.
They are the older style levers,not the shorter ones in your post.
As long as your fittings on the brake line are correct,you should have no problem.
You may want to get some CB perches to match the levers,if they dont fit your Yamaha ones.
I had to modify the Honda clutch lever with a grinder,to make it fit the perch!!
The front brake lever included a new reservoir
Good Luck

 

[Keenzo]

Sweet thanks one last question Dodger. whats are perches? lol

 

[bcware]

The perch is the part that attaches to the handle bar. The lever is the part you pull on with your fingers. The lever goes in the perch.

 

[dodger0129]

The perch is the part that attaches to the handle bar. The lever is the part you pull on with your fingers. The lever goes in the perch.

Could'nt have put it better