BigMacDouble
XS400 Enthusiast
Hey spent a couple hours cleaning this cam cover then when I went to install notice this insert which was thoroughly stuck. I’m guessing this is aluminum on steel galvanic corrosion from the rust build up seen through the screw hole.
So it’s basically welded in and there’s nothing much to grab onto anyways .
How should I proceed .
Are there any cables I could just put inside this .
Or maybe just grind it out with a dremel? I’ll probably ruin the worm gear .
Or just order a new cover which I hope it won’t come to .
So it’s basically welded in and there’s nothing much to grab onto anyways .
How should I proceed .
Are there any cables I could just put inside this .
Or maybe just grind it out with a dremel? I’ll probably ruin the worm gear .
Or just order a new cover which I hope it won’t come to .