buzzstpoint
XS400 Enthusiast
Did some reading and there have been many discussions saying you can't turn our rotors for the xs400.
Well I'm here to say you can. How do I know? I turned them myself.
Here's a small photo tutorial.
Get yourself a brake lathe.
Match up your cone,
Then match your cup.
Mount the rotor to the lathe, making sure it's square and doesn't wobble,
Spin IT!!
Then the finished product.
I ran out of time so I didn't measure the thickness of the rotor after I was done turning. Had 2 sets of car rotors to turn right after. I'll post the results tomorrow when I get back to work. I also have to order up my bearings for the front. (302S ((National bearings)).
Well I'm here to say you can. How do I know? I turned them myself.
Here's a small photo tutorial.
Get yourself a brake lathe.
Match up your cone,
Then match your cup.
Mount the rotor to the lathe, making sure it's square and doesn't wobble,
Spin IT!!
Then the finished product.
I ran out of time so I didn't measure the thickness of the rotor after I was done turning. Had 2 sets of car rotors to turn right after. I'll post the results tomorrow when I get back to work. I also have to order up my bearings for the front. (302S ((National bearings)).