Bobbed750
XS400 Member
Here is my first project, I'm feeling lazy so I'm just copying and pasting from another forum post.
Not reallt sure you can consider a bike a bobber if your fabricating over half of the frame, So I guess this one would be considered a chopper.
As she sat as of 3:30 today:
After the sawzall massacre,
lengthening the backbone and going single.
All joints into the factory frame will be slugged, radius welded along with 8 rosettes (4 on either side of jointed section)
Bending the upper rails
Welding them on
Not reallt sure you can consider a bike a bobber if your fabricating over half of the frame, So I guess this one would be considered a chopper.
As she sat as of 3:30 today:
![IMAG0903.jpg](http://i265.photobucket.com/albums/ii233/gohilla/IMAG0903.jpg)
After the sawzall massacre,
lengthening the backbone and going single.
![IMAG0905.jpg](http://i265.photobucket.com/albums/ii233/gohilla/IMAG0905.jpg)
All joints into the factory frame will be slugged, radius welded along with 8 rosettes (4 on either side of jointed section)
Bending the upper rails
![IMAG0910.jpg](http://i265.photobucket.com/albums/ii233/gohilla/IMAG0910.jpg)
Welding them on
![IMAG0919.jpg](http://i265.photobucket.com/albums/ii233/gohilla/IMAG0919.jpg)
![IMAG0915.jpg](http://i265.photobucket.com/albums/ii233/gohilla/IMAG0915.jpg)
![IMAG0917.jpg](http://i265.photobucket.com/albums/ii233/gohilla/IMAG0917.jpg)