Bobbed750
XS400 Member
Here is my first project, I'm feeling lazy so I'm just copying and pasting from another forum post.
Not reallt sure you can consider a bike a bobber if your fabricating over half of the frame, So I guess this one would be considered a chopper.
As she sat as of 3:30 today:
After the sawzall massacre,
lengthening the backbone and going single.
All joints into the factory frame will be slugged, radius welded along with 8 rosettes (4 on either side of jointed section)
Bending the upper rails
Welding them on
Not reallt sure you can consider a bike a bobber if your fabricating over half of the frame, So I guess this one would be considered a chopper.
As she sat as of 3:30 today:
After the sawzall massacre,
lengthening the backbone and going single.
All joints into the factory frame will be slugged, radius welded along with 8 rosettes (4 on either side of jointed section)
Bending the upper rails
Welding them on