Sesty
H.E. Pennypacker
Planning to adjust my clutch this week, engine doesn't engage until the lever is released 99% of the way out. Hoping its not a stretched cable and just out of adjustment.
The manual says 1. Break the locknut loose then 2. Tighten the screw down lightly than back out a bit and 3. Tighten the locknut backdown 4. Adjust the free play at the lever.
Before breaking loose the lock nut, do I have to loosen the locking wheel on the bars first? or can the adjustment be done down by the engine without messing with the bar end?
Anyone know if there is a torque spec for the locknut?
thanks!
The manual says 1. Break the locknut loose then 2. Tighten the screw down lightly than back out a bit and 3. Tighten the locknut backdown 4. Adjust the free play at the lever.
Before breaking loose the lock nut, do I have to loosen the locking wheel on the bars first? or can the adjustment be done down by the engine without messing with the bar end?
Anyone know if there is a torque spec for the locknut?
thanks!