Didn't I mention NO SKILL!? The lights that I used are direct replacements for the stock bulbs. I didn't get deep int the explanation of the installation (as I often do here on the forum
) but I thought it was self explanatory.
The easiest part? Justifying the purchase to yourself or significant other (brighter, safer, less draw, increases reliability of your bike)
Hardest part? Reading, understand, and following my instructions. Use your brain and skip these instructions for an easier install!
But for those who need an explanation, here are the steps
1) remove lens (two Phillips screws )
2) put on clean rubber gloves.
3) push bulbs in, then rotate to the left, pull bulbs out. Take note of where the "notches) on the bulb interface are. There is a "lower" one and "higher".
4) take new led bulb, configure with same position for low and high notches. Press bulb in, gently rotate to the right. (There should be no resistance in the rotating right. If there is, your notches are in the wrong spot, or your pressing too hard or not hard enough on the bulb spring).
5) turn on bike, make sure bulbs work, make sure brake light function works
6) put the lens back on
7) enjoy!