...and then there is the moment you would like to kick the PO's butt....virtually every screw is stripped out on my carbs, the appear to have been put on under power and reefed on pretty hard. I cannot get them to budge. I am going to soak the whole mess in solution and hope that loosens them up. After a trip to the hardware store to find replacement screws I work at the stripped screws with my newly acquired needle nose vise grips and was able to get all freed up...that was a relief. I have done some cleaning of the float bowls and the floats and the carb bore. Next up cleaning the little tubes and orifices...This whole project has been learning by doing and loads of helpful hints and links from folks on this forum.
Attachments
Last edited: